Henderson Cones & Cables

5.00 out of 5
(1 customer review)

From: £4.84 + VAT

INCLUDES

  • ROLL PINS
  • SPRING LOCK OUT
  • CONES & CABLES

9 in stock

SKU: HES1010 Category: Tags: ,

Description

Henderson Cones & Cables (pre 1992)

A pair of premium quality cones and cables to suit all pre February 1992 Henderson canopy doors including doubles, as opposed to the later Premiere range canopy doors, which have detachable cables.

Fitting Instructions

Warning – It is important that this instruction is
followed correctly as personal injury, damage to
cable or loss of pre-tension could occur.

All work to be carried out from inside the garage.

Tools required: Screwdriver, Hammer, 4mm pin punch, 1/4″ diameter
toggle bar.

Note: You will need assistance when replacing and removing the crook pin. In order to ease the spring pressure place a 1/4″ diameter
toggle bar into the hole in the spring plug as shown, and turn it upwards. This will allow the crook pin to be inserted or removed.

Removal and replacement instructions.

1. Remove the door as follows:
a. Insert the crook pin into the right hand head
bracket
b. Wedge the door in the opening so it will not move
c. Unscrew and remove the side jamb channels
d. Remove the head bracket bolt and lower the spring
e. Lift the door from the opening
2. Remove the spring assembly by withdrawing the split pins
holding the link arms to the head brackets. Remove the
looped end of the cable from the roller spindles
3. Support the spring and drive the hollow roll pin from one
cone using a 4mm pin punch. Remove the old cone and re-fit
the replacement.
Note: change one cone at a time as they are handed left and
right, (the cable must emerge the same way as the original).
Repeat the procedure for the other cone making sure that
both cables emerge from the cones on the same side of the
shaft
4. Re-fit the spring and then reinstall the door by following the removal instructions in reverse. Before removing the crook
pin ensure that the looped ends of the cable are within the recessed diameter of the roller spindle as shown.

Note: You will need assistance when removing the crook pin. In order to ease the spring pressure place a toggle bar into the hole in the spring plug and turn it upwards an hold it while an assistant removes the crook pin using a screwdriver. Slowly lower the toggle bar whilst checking that both cables are routed correctly down the jamb channels and engaged correctly into the roller
spindle groves.

5. Lubricate roller spindles, top latch and all other moving parts. To ensure continued ease of operation lubricate periodically.

All work is undertaken at your own risk.
SKU: HES1010

1 review for Henderson Cones & Cables

  1. 5 out of 5

    admin

    Great Product, Delivered Quickly

Add a review